Frequently asked questions
Allremote Searchlight General Programming Instruction
A.Before programming:
*User should check batteries status is full or poor.
Handheld remote use 23A battery ; Wireless joystick use DC power from user own DC power.
*Only transmitter replaced or repaired need to be programmed.
Factory default is programmed.
*Make sure there is no any RF wireless devices operating nearby to avoid interface.
B.Programming:
​ (Note : keep 50cm distance between remote and searchlight when you proceed programming)
Step1 : Disconnect or switch off searchlight DC power.
Step2 : Reconnect or switch on searchlight DC power.
Within 5 seconds,
Press up and down button (handheld remote) or programming button (wireless joystick)
*Note:Unlike Searchlight its self, wireless joystick has to keep power on during programming.
-----------Searchlight will bright 1~4 times when transmitter acknowledged-------------
Step3 : Leave searchlight alone to close programming or program 2nd transmitter within next 5 seconds.
*One searchlight accepts 4 transmitters at most. 5th will replace the 1st one position.
Step1 :
Step2 :
Single remote programming
